Zein da 6061-O eta 6061-T6 aluminiozko xaflaren arteko aldea?
6061-O aluminum sheet and 6061-T6 aluminum sheet are two common specifications of aluminum sheets in the 6000 seriea 6061. Ezaugarri hobeak dituzte. Zein da 6061-O eta 6061-T6 aluminiozko xaflen arteko aldea? 6061-O eta 6061-T6 aluminiozko plaken arteko desberdintasun nagusia propietate mekanikoak dira., especially strength and hardness, which are affected by the tempering process.
6061-O aluminum plate:
Tenperatura: O (annealed)
Mechanical behavior:
Trakzio Erresistentzia: Typically approximately 124 MPa (18 ksi)
Etekin-indarra: Typically approximately 55 MPa (8 ksi)
Luzapena: usually around 25%
Gogortasuna: lower
Formagarritasuna: Excellent formability due to its softness. It can be molded, makurtuta, and molded easily without cracking or weakening.
Typical uses:
Typically used in applications where high strength is not a critical requirement but formability and corrosion resistance are critical.
Ideal for applications requiring deep drawing or forming processes such as automotive parts, cans and kitchenware.
6061-T6 aluminum plate:
Condition: T6 (solution heat treatment and artificial aging)
Mechanical behavior:
Trakzio Erresistentzia: Typically approximately 310 MPa (45 ksi)
Etekin-indarra: Typically approximately 275 MPa (40 ksi)
Luzapena: usually around 12%
Gogortasuna: Harder compared to 6061-O due to precipitation hardening process.
Formagarritasuna: Although still formable, 6061-T6 is less ductile than 6061-O due to increased strength and hardness. It may require more force to bend or form.
Typical uses:
Structural applications requiring high strength and good corrosion resistance, such as aerospace components, bicycle frames and structural components in construction.
Machined components requiring high strength and excellent machining properties.
Comparison Table:
Jabetza | 6061-O Aluminum Sheet | 6061-T6 aluminiozko xafla |
---|
Trakzio Erresistentzia | Typically around 124 MPa (18 ksi) | Typically around 310 MPa (45 ksi) |
Etekin-indarra | Typically around 55 MPa (8 ksi) | Typically around 275 MPa (40 ksi) |
Luzapena | Typically around 25% | Typically around 12% |
Gogortasuna | Relatively low | Higher |
Formagarritasuna | Bikaina | Formable, but less malleable |
Typical Uses | Deep drawing, forming processes | Egitura-aplikazioak, machined components |